This page is for the RS5 red laser scanner. For the AS1 blue laser scanner, see this page.

The following RDS RSx setup is recommended for using VTube-LASER with HEXAGON arms and the RS5 and RS3 (red laser) scanners.

• 1 - Capture mode: "Keep button pressed"
• 2 - Scanning profile: Save a profile named "VTube" (Do this last - after you have set both 3 and 4.)
• 3 - Point sampling - Set it as low as possible. The lower setting is still a lot of data from HEXAGON.
• 4 - Exposure mode: Auto

How to Setup RDS for the RS5 Scanner

Make sure your Connection Control Pack is correctly selected

How to Setup RDS for the RS3 Scanner

To make changes to the settings, you will need to enter Advanced mode.

1 - Click on the Standard button in the upper right corner.

2. Enter the password: Advanced

3. Make the changes to the values as shown in the first screen image above.

4. Save a new Profile (a laser configuration) called "VTube".

5. Press Save in the lower right.

6. Press Quit.

7. Be sure that the VTube scanning profile is used for scanning in VTube-LASER.

8. This shows the profile being used in a smaller popup window.

How Fix RDS when the RDS Service Will Not Start

If the RDS Service will not Run (image here shows running), the "Stop" button will read "Start". If when you press "Start" RDS does not start, then an uninstall and reinstall of RDS may be necessary.

.